Need metal roof installation in Duck Creek Village? We come look first, tell you plainly what it needs, and put the price in writing before anything starts.
A metal roof is what Roofing Brothers is known for, and it has been since 2002. On a Duck Creek Village home that means standing seam or exposed fastener panels set over sound decking and real underlayment, with the ridge, valley and eave trim cut and fit on site rather than forced out of a box.
Not every Duck Creek Village roof needs the biggest job on the sheet. When we quote metal roof installation we tell you honestly whether a repair will hold, whether doing one section will do, or whether you are genuinely past that — and we would rather do the smaller job well.
Metal is our specialty, so if metal roof installation on your Duck Creek Village home opens the door to standing seam or a panel roof, we will price that right alongside the shingle option and let you compare the real numbers side by side.
Four steps and no surprises. This is how we have done it since 2002.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
Rotten decking gets replaced and priced with you before it is covered up. Nobody wants to learn about that afterward.
Synthetic underlayment over the whole roof, ice and water shield in the valleys and at the eaves, then panels set square on the correct fastener spacing.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
What comes up on just about every estimate for a job like this.
Much less than people expect. Over solid decking with underlayment, a Duck Creek Village metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Duck Creek Village homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Installed properly over sound decking, a metal roof should give a Duck Creek Village home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
A straightforward Duck Creek Village house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
Real feedback from homeowners we have worked for.
"The skylight had leaked for two years and three different people had caulked it. These folks reflashed it properly and that was the end of it."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Ice was backing up at our eaves every winter. They cleared it, then went back and fixed the ventilation, and we have not had the problem since."